Filter
Top Products
49
English
INTRODUCTION
PREPARATION
BASIC
OPERAIONT
ADVANCED
OPERATION
ADDITIONAL
INFORMATION
APPENDIX
REMOTE CONTROL FEATURES
The remote control can operate this unit as well as other YAMAHA A/V components. To control the components from
other manufacturers (or some from YAMAHA), you must set up the remote control with the manufacturer codes.
This remote control also has a sophisticated feature: Learn. The Learn feature allows it to acquire functions from the
remote controls of other components in your system (or other household appliances) equipped with a infrared remote
control receiver. This feature makes it possible for you to reduce the number of remote control in your entertainment
room.
Notes
• For the operating distance of the remote contorol and notes about batteries, see pages 3 and 8.
• For the name and function of each part and button, see pages 6 to 8.
• If the memory on the remote control becomes full, no further learning is possible, even if there are still some programmable buttons
available (see page 55).
Selector Dial
There are 9 positions that you can select to control connected components with this remote control. For example, if the
CD position is selected, the remote control is set in the CD operation mode, allowing the CD player to be controlled by
the buttons on the remote control. When turning the selector dial, the position changes as follows:
Selector
dial
AMP/TUN
You can perform the basic operations of
this unit. See pages 6 and 7.
CD
The code for a YAMAHA CD
player is factory-set.
CBL/SAT
A cable TV or satellite tuner can be controlled.
VCR
A VCR can be controlled.
TV
A TV can be controlled.
TAPE/MD
The code for a YAMAHA tape deck is factory-
set. Be sure to set the proper code when
operating an MD recorder or CD recorder.
DVD/LD & DVD MENU
An LD player can be controlled in
the DVD/LD position. A DVD player
can be controlled in the DVD/LD and
DVD MENU positions. The code for
a YAMAHA DVD player is factory-
set. If the remote control does not
operate your YAMAHA DVD player,
you need to set the code number
“0048”.
DSP/TUN
This unit can be controlled and DSP
programs can be selected directly.
Note
• The general operational buttons on the remote control differ depending on the position of the selector dial. See the following pages
for details.