Filter
Top Products
PAGE 33
206-3489-O
Installer menus
Some of the functions shown above may not be available on your TV (such as FM).
Use the Installer menus to make adjustments
The range of values is 0 - 255. Use (adjust) keys to choose: (1)
With number 255 the feature is inactive. (2) Other numbers deter-
mine the start channel. (3) Set the volume level as desired before
exiting the Installer menu. 0 is the “AUX” channel.
11 HOSPITAL MODE
Not used in Concierge-series TVs. Leave at default setting 0.
12 CHAN LOCK (Channel Lock)
When set to 1 the CHAN LOCK is ideal if a cable box (or similar) is
the sole source for programming—and the TV must always be on
the same channel. Changing channels with the Channel up/down
or or keypad numbers is impossible. Channel Lock is inactive
when set to 0 (default).
Generally, this feature is used in connection with START
CHAN/VOL (line 11) where the start channel may, for example, be
set to 3 or 4. If the start channel is 3 then the TV will remain on
channel 3. NOTE: When channel lock is active AUTO PROGRAM and
CH. ADD/DEL in the SETUP MENU are not active.
13 GHOST CH. (Ghost Channel)
When set to 1, the current channel number is displayed in the
upper right corner of the CRT. The number moves slightly to pre-
vent damage to the screen. The default is “0” or OFF. NOTE: When
captions are on, the “ghost channel” is not displayed.
14 SCAN MODE
Allows variation in setting the On/Off with Channel UP/DOWN.
You may opt for TV channels only; TV channels + Off/ON; TV chan-
nels + FM radio; TV channels + FM radio + Off/On with these set-
tings for Scan Mode:
Scan mode Characteristics
0 Channel up/down keys change chan-
nels only.
1 Channel down below the lowest
channel (or channel up higher than
the highest) and TV turns off.
2 Channel Up/Down + FM.
3 Channel Up/Down + Off/On.
15 TEXT MODE
Determines whether TEXT 1, TEXT 2,TEXT 3, or TEXT 4 decoding is
enabled when TEXT is turned on (either from the Setup Menu or
directly with CC on the remote).
TIP: Set Text Mode to 1 only if text is offered in your video sys-
tem.
16 SLEEP TIMER
When set to 1, the SLEEP TIMER feature may be used (but no
message is displayed prior to turn-off). When set to 0, the sleep
timer is not available.
17 ALARM
Gives you the option of making the alarm function available to
the end-user. Set to 1, alarm function is available. Set to 0 to
withhold this function. The clock must be set in order to use the
alarm.
18 CH. OVERRIDE (Channel Override)
When set to 1, the user is allowed to select channels with either
Channel up/down or by direct keypad entry. When set to 0, only
those channels that are entered for scanning may be selected.
19. OLD OCV (On Command Video)
Set to 1 for operation with “SpectraMate” systems from On
Command Corporation.
20. CAPTION LOCK
Set to 1 to restore previous caption On/Off state after TV turns
off when set to 0, captions are always off when TV is initially
turned on.
21. FUNCTION PRE
Set to 0 to suppress CHANNEL PREVIEW FUNCTION menu with
some pay per view systems.
22. FEATURE LEVEL
Set to ZEN 1 for Zenith compatible remote control operation, set
to 0 for PLbl for Zenith private label compatible remote control
operation.