Zenith H20H52DT CRT Television User Manual


 
Auto Program (Channel Search)
Page 12
123
4456
7
0
8
ENTER
9
POWER
T
V/
F
M
LHFSB
K
T
E
M
U
L
UM
V
O
E
C
A
NH
N
E
L
MENU
ADJ ADJ
SELECT
TIMER
BANK
CH PREVIEW
BED 1
BED 2
C
C
-
+
-
+
3/5
AUTO PROGRAM
ADD/DEL/BLNK
CH. LABELS
CLOCK SET
TIMER
CAPTIONS
LANGUAGE
4/6
1
7
2
With the optional Installer remote control in hand,
press the POWER key to turn on the HealthView TV.
Press the MENU key to show the Setup menu.
Using SELECT on the remote control, highlight Auto
Program on the screen.
Press the Right or Left ADJ (Adjust) arrow to go to
the Auto Program menu.
Using SELECT, choose either Cable TV or Off Air
Antenna on the screen.
Press the Right or Left ADJ arrow to begin the
Channel Search.
Press ENTER when the channel search is complete.
Auto Program finds channels being received by the
TV tuner.
Cable will not work unless the hospital provides a
cable service.
Optional Installer and Patient Remote Controls:
Shown herein are optional remote controls that can be used by
the installer and the patient. Be advise that these remote
controls are NOT included with this TV. However, these remotes
can be purchased separately, see your Zenith dealer.
1
2
3
4
5
6
7
Use Auto Program to specify Cable TV or Off Air Antenna
incoming signal source and automatically store in the memory of
the TV, all of the channels that are found by the channel search.
If the patient can only view over-the-air broadcast, select Antenna.
If you provide cable service to the patients, select Cable.
OFF AIR ANTENNA
CABLE
Mini Glossary