Zenith H20H52DT CRT Television User Manual


 
Clone Selection Menu Choices
Page 43
Operation Notes
Disconnect the Clone from the TV when you are
finished; automatically switching it off. The real-
time clock continues to run when the main circuits
are switched off.
Reset Clone After Static Shock
After replacing exhausted batteries, or if the
programmer behaves strangely after a static
shock, use a paper clip or similar instrument
inserted through the small hole marked ”RESET”
to activate the internal reset switch and restore
normal operation.
After a reset, check the real-time clock setting. It
may be necessary to reset the Clone Programmer
clock from a TV containing the correct time.
The LT2000 programmer is designed to be used
with TVs containing the 221-01006 and later
processors. Use with earlier TV sets
may give unpredictable results. The specific
microprocessor used in any TV set may be
determined by activating the Installer
Menu. The microprocessor part number appears
at the top of the screen when the Installer Menu is
activated. Processors before the 221-01006-04
have a limited screen display capability. They
can not display entire screens as shown in the
quick setup instructions accompanying the
LT2000 clone programmer. Use the printed menu
illustrations on the quick setup sheet supplied
with the Clone as an aid to making your
programming choices. (Although the menus are
not all displayed, the clone functions all operate
normally).
Troubleshooting
Problem Possible Cause(s) Possible Solution(s)
Clone Programmer
LED does not blink. • M.P.I. cord not connected. -Connect M.P.I. cord.
• TV not turned on. -TV must be on for clone to
work.
• Weak batteries. -Install 4 fresh AA high-quality
alkaline batteries.
Clone menu hard • Weak signal. -Connect TV to a reliable signal
to read. Source.
No time set. • No time on Master TV. -Set time on master TV, copy
time to Clone Programmer.
Menu items 7-8 not • Not necessary. -Channel Labels already cloned;
if they were on Master TV.
on clone selection menu.
Master and Other TVs
Cloning did not work. • Procedure interrupted. -Wait until procedure complete message
is displayed.
• Different TV models. -Cloning is only possible with identical
model TVs.
Clone time disappeared. • Batteries were removed. -Batteries must remain installed to retain
time settings.
Channel Labels not • Saved to other memory. -Must save channel labels to same
present on cloned TV. memory bank as master TV setup.
New Setup not present. • TV not reset. -Disconnect newly cloned TV from power
for 5 seconds.
When cloning operations are complete, just unplug the LT2000 from the TV.
If the TV does not display a picture (blank screen) after a few seconds, just change channels.