Zenith R49W36 Projection Television User Manual


 
PAGE 10
206-03865
Cable Box Connections
Locate the Antenna/Cable 2 jack on the
back of your TV. Connect the cable that
runs from the wall directly or antenna to
the jack. Now find the Loop Out jack.
Connect the cable from this jack to the
Input jack on the back of your cable box.
Locate the Output jack on the back of
your cable box. Connect this to the
Antenna/Cable 1 jack on the back of your
TV.
To view the premium stations, press the
TV/VIDEO button on your remote and
select the other Cable source (Ant/Cable
1). Then tune the channel number on
your cable box for HBO, CINEMAX, SHOW-
TIME, etc.
To view non-premium channels press the
TV/VIDEO button and select Ant/Cable 2.
Then run EZ Scan to find all available
channels and store them in memory.
This can be combined with any other
equipment you may want to hook up, see
following pages. Connect cable service
wire directly to the TV, loop out from the
TV, then to the cable box. From there, the
cable box output connects to the next
device in the connection series, until the
last device, which connects back to the
Antenna/Cable 1 jack on the TV.
1
2
3
4
Some cable services require the use of a cable box to decode pre-
mium channels and pay-per-view. Using the Loop Out to Decoder
connection option, and programming your remote, you can con-
nect your cable box so that you only need your MBR remote to
tune to premium and non-premium channels. By connecting a
cable box directly to your TV, as shown to the LOOP OUT, you
make the cable box another available channel tuning source using
your remote.
S-VIDEO
ANT/CABLE1
INPUT
ANT/CABLE2
INPUT
LOOP OUT
(R)
(L)
VIDEO
(MONO)
AUDIO
MNT
OUT
IN 2
IN 1
In
Out
Cable box
Cable TV Wall jack