Zenith R49W36 Projection Television User Manual


 
PAGE 54
206-03865
Troubleshooting, contd
SYMPTOM
Remote control doesnt work.
Menu options cant be
changed or selected.
No picture or sound
when any non-cable source
is selected.
Weak or no Stereo Sound
when using a stereo VCR.
The PIP inset is black or
lacks contrast.
The PIP inset is snowy when
the source is TV.
Time is incorrect.
POSSIBLE SOLUTIONS
Make sure the batteries are fresh and installed properly.
Try unplugging your TV for a few minutes,
then plug it back in.
Check to see if the source equipment has been turned on.
Make sure that the connections are secure on the back of your TV and on the
source equipment.
Check to see if all the connections are secure.
Look in the Audio mode menu to see if all the settings are correct.
You are using channel 3 or 4 to view your VCR. No stereo sound is present
under that decision.
Check to be sure that the PIP source is turned on.
Check that all the wires are connected properly.
Check to see if your input source for PIP is set correctly.
Look to see if the TV/VCR button on your VCR has the TV selected or change
the PIP to another source.
Make sure the time was set initially. Probably power was lost.