Filter
Top Products
Owner’s Manual 39
Programming the Remote
Programming the Remote
Programming the Remote
1. Test your Remote Control.
To find out whether your remote control can operate the device
with out programming, turn on the device such as a the VCR
and press the corresponding mode button (VCR) on the remote
control while pointing at the device. Test the POWER and
CH +/- buttons to see if the device responds properly. If not, the
remote requires programming to operate the device.
2. Turn on the device to be programmed. Then press the cor
responding mode button on the Remote Control.
3. Press the POWER button and the MUTE button simulta
neously. Now the Remote Control is ready to program the
code for the corresponding device.
4. There are two ways to find the right code for the device.
A. If you press the CH +/- buttons repeatedly, the codes will
change one at a time. Press the POWER button after each
code change. If the right code is found, the device will turn off.
B. Enter a code number using the number buttons on the Remote
Control. The right code numbers for the corresponding compo-
nent can be found on the following pages.
Again, if the code is correct, the device will turn off.
5. Press the EXIT button to store the program.
6. Test the Remote Control functions to see if the device
responds properly. If not, repeat from step 2.
1 2 3
4 5 6
7 8 9
0
TV
MODE
LIGHT
POWER
TV/VIDEO
INFO
SLEEP
VCR
CABLE
DVD
SAT
MUTE
SWAPPIPCH- PIPCH+
PIP
RATIO
RECORD
STOP
PAUSE
REW
PLAY
FF
MENU EXIT
CC FREEZE
PIP INPUT
VOL
CH
FAV
SAP
ADJUST
EZ SoundEZ Video
TV INPUT
SKIP
FLASHBK
+
-
2
4
5
3
4
The Remote Control for your HD receiver is a multi-brand or universal Remote Control that can
be programmed to operate most remote-controllable devices of other manufacturers.
Note: The Remote Control may not be able to control all models of other brands.
3
Downloaded from www.Manualslib.com manuals search engine