4600 Series IP Telephone Installation
Dynamic Addressing Process
2-7
Since the read request packet may have to be sent several times, each time the RRQ
message is sent, the following message is displayed:
6. While the upgrade script file is being downloaded, the following message is displayed:
where n is the number of KBs received from the TFTP server.
7. While the application file is downloaded to the IP Telephone, the following message is
displayed:
where n is the number of KBs received from the TFTP server.
8. While the application file is saved in flash memory, the following message is displayed:
with the percentage of the file and the number of elapsed seconds incremented as the
application file is stored in flash memory.
9. The phone contacts the DEFINITY server and attempts to log in.
The following prompt for an extension is displayed:
10. Enter a new extension, ending with the # button.
If the extension is not in use, the following prompt for a password is displayed:
11. Enter the password, ending with the # button.
While the telephone’s extension is visible as you enter it, the password is displayed as
asterisks.
12. The system determines whether the extension is in use.
13. Successful completion of this process causes the dial tone to be available.
The IP Telephone has been installed successfully.
TFTP: s secs
46xxUPGRADE.SCR
n KB received
filename
n KB received
Saving to flash
1%, 1 secs
Extension=nnnnnn
#=OK NEW=_
Password=_
#=OK
