42
➮ Use the buttons : to set the
desired degree of sensitivity.
➮ When you have completed the set-
tings, press the MENU button 8
or the OK buttons ;.
Storing stations
Storing stations manually
➮ Select the required FM memory
level, FM1, FM2, FMT or either
waveband MW or LW.
➮ Tune into the desired station.
➮ Hold down one of the preset sta-
tion buttons 1 - 6 > on which you
wish to store the station for more
than two seconds.
Storing stations automatically
(Travelstore)
You can store the six stations with the
strongest reception in the region auto-
matically (only FM). The stations are
stored in the FMT memory.
Note:
Stations that were previously stored in
this memory are deleted in the process.
➮ Hold down the BND / TS button 5
for more than two seconds.
The automatic station-storing procedure
begins. “TRAVEL-STORE” appears on
the display. Once the process is com-
pleted, the station stored in FMT mem-
ory location 1 is played.
Listening to preset stations
➮ Select the memory or frequency
range.
➮ Hold down the preset station but-
ton 1 - 6 > of the desired station.
Scanning receivable stations
(SCAN)
You can briefly listen in to all receivable
stations. The scanning time can be set
in the menu at between 5 and 30 sec-
onds.
Starting SCAN
➮ Hold down the OK button ; for
more than two seconds.
The scanning process begins. “SCAN”
appears briefly on the display, followed
by the current station name or frequen-
cy, which flashes.
Ending SCAN, continuing to listen
to a station
➮ Press the OK button ;.
The scanning process is completed, the
station last scanned remains active.
Setting the scanning time
➮ Press the MENU button 8.
➮ Press the button : repeatedly
until “SCANTIME” appears on the
display.
➮ Use the buttons : to set the
desired scanning time.
➮ Once the setting has been com-
pleted, press the MENU button 8
or OK ;.
Note:
The set scantime also applies to scan-
ning in CD mode but not to scanning in
CD changer mode.
RADIO MODE
