8
To “train” a new KeyCard as a replacement
for a lost or unusable KeyCard:
➮ Insert the remaining valid KeyCard and
switch on the unit.
➮ Press the MENU button 8.
➮ Press the soft key 4 with the display
allocation “KC”.
➮ Press the soft key 4 with the display
allocation “LRN”.
The display will read “LEARN KC”.
➮ Remove the first KeyCard.
The display will read “INSERT”.
➮ Insert the new KeyCard.
The display will read “LEARN OK”.
To exit the KeyCard menu
➮ press the MENU button 8 or the OK
button 5.
Now the car radio can be used with two Key-
Cards again.
Lost or damaged KeyCards
If all of the KeyCards belonging to a unit have
been lost or damaged, first a new KeyCard
with the master code of the unit must be
“trained”. The master code of the unit is con-
tained in the radio pass.
Always keep the radio pass in a safe
place, but never in your vehicle.
To “train” a new KeyCard, follow the instruc-
tions given in the section “Training a new Key-
Card / entering the master code”.
If necessary, you can use this KeyCard to train
a second KeyCard. For instructions on how
to do this, read the section “Replacing / train-
ing KeyCards”.
New KeyCards can be obtained from your
dealer.
“Training” a new KeyCard /
entering the master code
If you no longer have any valid KeyCards for
your unit and want to “train” a new KeyCard:
➮ Insert a new KeyCard that is unknown
to the unit.
➮ Close the operating panel.
➮ Turn off the unit if necessary.
➮ Simultaneously hold down the TUNE
button > and the second soft key 4
from the top on the left side 2.
The display will read “0000”.
Enter the four-digit master code from the ra-
dio pass as follows:
➮ Use the / buttons 7 to enter the
respective digits of the master code.
Press the buttons until the desired num-
ber appears on the display.
➮ Use the buttons 7 to move from
one digit to the next during input.
➮ Once the master code is displayed cor-
rectly, press the OK button 5.
The new KeyCard is accepted when the unit
switches to play.
Optical theft protection indicator
(LED)
The ON/OFF button and the CD bay illumi-
nation can be set to blink when the unit is off
and the KeyCard has been removed. To do
this, the menu setting “LED” must be set to
“ON”.
➮ Press the MENU button 8.
➮ Press the soft key 4 with the display
allocation “KC”.
➮ Press the soft key 4 with the display
allocation “LED”.
The display will show the current status “LED
ON” or “LED OFF”.
THEFT PROTECTION
