57
Settings for Shooting
3
Setting Processing Parameters
With the parameters already set, when you set the < > switch to < >, the camera
will start up and display “
” on the LCD panel until it is ready for shooting. Then the
parameter settings will be displayed. If [Set 1], [Set 2], or [Set 3] has been set, “ ”,
“
”, or “ ” will be displayed. And if [Adobe RGB] (→p.58) has been set, “ ”
will be displayed.
With C.Fn-01-2, you can set [Parameters] by pressing < > and turning the < > dial
while looking at the LCD panel. (→p.146)
Select the parameter.
•
Turn the < > dial to select the parameter, then
press <
>.
•
The parameter selection will change in the following
loop:
4
Set the parameter.
•
Turn the < > dial to set the parameter, then press
<
>.
•
Each parameter can be set to one of five settings.
5
Return to the [Parameters] menu.
•
Press the < > button twice to return to step 1.
Then press <
>.
6
Select the Set No. that was set.
•
Turn the < > dial to select [Set 1], [Set 2], or [Set
3], then press <
>.
s
After the setting is completed, the menu will
reappear.
•
To exit the menu and turn off the LCD monitor,
press the <
> button.
7
[Contrast]
[Sharpness]
[Color tone]
[Saturation]
