Page
2 -25 3.4.5 Setting the EEPROM
2 -26 4. OPERATION CHECK AFTER DISASSEMBLY AND REASSEMBLY
2 -26 4.1 Check Procedure
2 -27 5. TRANSPORTING THE PRINTER
2 -27 5.1 Procedure
2 -28 6. PARTS REPLACEMENT, PERIODIC INSPECTIONS, & TOOLS
2 -28 6.1 Parts Replacement
2 -28 6.2 Periodic Inspections
2 -28 6.3 Tool List
2 -29 7. SERVICE-RELATED FEATURES
2 -29 7.1 Service Mode Operations
2 -30 7.2 Test Printout
2 -31 7.3 Printing the EEPROM Information
2 -32 7.4 Resetting the EEPROM
2 -32 7.5 Setting the Printer Settings in the EEPROM
Part 3: TECHNICAL REFERENCE
3 - 1 1. PRINTER CONTROL SECTION
3 - 1 1.1 Printing Data and Control Signal Flow
3 - 2 1.2 Print Drive Method
3 - 3 1.2.1 Print drive control
3 - 4 1.2.2 Print driving method
3 - 5 1.3 Control During Printing
3 - 5 1.3.1 2-dot Pair + Bi-directional printing
3 - 5 1.3.2 Seam stripe control
3 - 5 1.3.3 Rest between scans (Border detection control)
3 - 6 1.3.4 Smear control and rest between pages
3 - 6 1.3.5 Automatic power ON/OFF
3 - 6 1.3.6 Print head protection from overheating
3 - 6 1.3.7 Power motor control
3 - 7 1.4 Detection Functions
3 - 7 1.4.1 Detection by sensors
3 - 7 1.4.2 Paper-end sensor
3 - 8 1.4.3 Ink sensor (Same as for BJ F600)
3 - 8 1.4.4 Cover sensor
3 - 8 1.4.5 Pump sensor
3 - 9 1.4.6 Internal temperature sensor
3 - 9 1.4.7 Head temperature sensor
3 - 9 1.4.8 ASF sensor
3 - 9 1.4.9 Carriage encoder/paper feed encoder
3 - 9 1.5 Other Sensing Features
3 - 9 1.5.1 Waste-ink detection
3 - 9 1.5.2 Print head detection
3 -10 2. ELECTRICAL DRIVE SECTION
3 -10 2.1 Block Diagram
3 -11 2.2 Electrical Section
3 -12 3. PRINTER'S MECHANICAL PARTS
3 -12 3.1 Overview of the Printer's Mechanical Parts
3 -12 3.1.1 Carriage
3 -12 3.1.2 Purge section
3 -13 3.1.3 Paper feed section
3 -14 3.2 Purge Section
3 -14 3.2.1 Purge section functions
III
