xStack
®
DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
59
show config
Purpose Used to display the current or saved version of the configuration settings of the switch.
Syntax
show config [current_config | config_in_nvram <config_id 1–2> | information]
Use this command to display all the configuration settings that are saved to NV RAM or
display the configuration settings as they are currently configured. Use the keyboard to
list settings one line at a time (Enter), one page at a time (Space) or view all (a).
The configuration settings are listed by category in the following order:
Description
1. Stack
2. Double VLAN
3. Basic (serial port, Telnet and
web management status)
4. Account List
5. storm control
6. IP group management
7. syslog
8. QoS
9. port mirroring
10. traffic segmentation
11. SSL
12. port
13. PoE
14. Port lock
15. SNMPv3
16. MANAGEMENT
17. VLAN
18. 802.1X
19. Guest VLAN
20. TR
21. ACL
22. FDB (forwarding data base)
23. Address Binding
24. MAC Address Table Notification
25. STP
26. SAFEGUARD ENGINE
27. BANNER PROMPT
28. SSH
29. SNTP
30. LACP
31. IP and auto config
32. IGMP Snooping
33. MLD Snooping
34. ACCESS AUTHENTICATION
CONTROL
35. DHCP Relay
36. IPv6 Neighbor Detection
37. ARP
38. Route
Parameters current_config – Entering this parameter will display configurations entered without being
saved to NVRAM.
config_in_nvram <config_id 1–2> – Entering this parameter will display configurations to
be specified <config_id 1
–
2> which were saved in NV–RAM.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To view the current configuration settings:
