The Font Cartridges
5. If the power is on, press ON LINE to set the printer on line. If
the power is off, simply turn on the printer.
Now that you have inserted a font cartridge, you can select the
fonts you want to print using SelecType or your application
program.
Selecting a font with your application program
When the printer is in HP emulation mode, you can use your
application program to select the fonts you want to print. First be
sure you selected HP LaserJet series IIP or a similar printer from
the program’s setup or installation menu. For more information on
which printers to choose when you set up your application
program, see the section on using your printer with software in
Chapter 5. After you set up your application program, you can
specify the fonts you want using the commands available in the
program.
If your program does not provide commands that allow you to
select the font you want, you can select fonts using SelecType
menus or printer command sequences. Most application programs,
however, allow you to select fonts, and you should not have to use
SelecType or printer commands to do so. To select a font using
SelecType, see the next section. For information on printer
commands, see Appendix B. Also see your software manual for
information on how to use printer command sequences.
A-6
Appendix A
