A SERVICE OF

logo

5-38
SelecType
Before printing in the EPSON GL/2 mode
You may need to change printer settings depending on your
output needs. Always check the printer’s setting to make sure
they match the data you are tying to print. Before you switch
conflicts with the printer’s settings:
Paper size:Printer’s paper size setting
Driver (plotter selection):HP-GL/2 or HP-GL plotters
If you need to configure the printer settings, first switch the
emulation and then change the settings using the printer driver
or SelecType.
c
Caution:
Settings or data saved in printer RAM (such as download fonts)
may be erased when you switch emulation.
PG, AF
commands
Not supported Supported
Results when a DT
command with no
second
parameter is sent
Terminator is not
plotted
Terminator is plotted
ESC %#A
commands
Supported Not supported
Command HP GL/2 mode EPSON GL/2 mode