66
7. Using the Firmware Updater
This application software is used to update the firmware installed in the scanner device.
However, this application software is automatically executed when the driver installation is
completed. If the software is executed at the installation, it is not necessary to execute again.
This application software shall be used only for the following devices. Do not use for other
devices.
Applicable Devices: fi-4750, M4097D, fi-4750C
Check items before use.
Before using this application software, check the following items.
- Check that the scanner is connected properly. If more than one scanner are connected,
the update cannot be done correctly. Connect one scanner only that has the firmware to
be updated.
- If the driver has been activated, close the application software that is using the driver.
How to use
Select as follows: [Start] - [Program] - [Scanner Utility for Microsoft Windows], then
[Firmware Updater]
The program is executed and the following dialog box appears.
Press the [Yes] button. The following dialog box is displayed and the firmware update starts.
* Do not turn off the power of the scanner during the firmware update. Otherwise the device
may break down.
