A SERVICE OF

logo

Chapter 2 Network Connection Specifications 2-11
2.2.4 Cable Connector
The interface cable has the following specifications.
Connector type
D-SUB9 pin Male (install side: Female)
DEU-9PF-F0 (from JAE Electronics Engineering Company, or equivalent)
Terminal array
FIGURE 2-6 identifies pin signals of the UPC connector and the UPS cable.
Do not use the unused pins (pin number 2, 3, 4 and 8 in the following diagram).
Cable side shown below.
FIGURE 2-6 Corresponding Terminals in UPC Connector and the UPS Cable
Note – If you need UPC cables, you need to make arrangements separately. For
details, contact your sales representatives.
Note: Do not use ER signal.
(Note)
*BTL
*BPS/*UALM
*ACOFF
SG
ER
Cable side
*BTL
*BPS/*UALM
*ACOFF
SG
1
2
3
4
5
6
7
8
9
Signal name
---
---
---
---
This system side
Pin #