Ÿ 8. Your gate system is required to have a primary and a secondary
entrapment safety system installed and maintained.
Ÿ 9. If your gate closes automatically, loop detectors should be installed
to detect the presence of a vehicle.
Ÿ 10. DO NOT increase force adjustment to compensate for a damaged
gate. The gate should always be maintained to operate manually as
easily as possible to provide maximum protection.
Ÿ 11. Check all safety systems at least once per month for the correct
force, speed and sensitivity. Gate must reverse when hitting a rigid
object, or when a non-contact sensor is activated. If these functions
are observed to operate improperly, discontinue use and have it
serviced immediately!
Ÿ 12. You are responsible for ensuring that warning signs are installed
and maintained on both sides of your gate.
Ÿ 13. To ensure safe operation of this equipment, you must read this
safety manual and keep it for reference.
MANUAL DISCONNECT OPERATION
Ÿ Your operator is equipped with a pad lockable emergency disconnect for
manual operation. Be sure you have a key and understand how to
operate this equipment. To disengage operator, move red disconnect
lever to the left and latch it in place.
Ÿ WARNING: NEVER OPERATE THE MANUAL RELEASE WHEN THE
GATE IS MOVING.
TO DISCONNECT DRIVE:
PULL DISCONNECT ARM OUT,
THEN MOVE TO THE RIGHT
TO LATCH INTO POSITION.
TO RE-ENGAGE DRIVE:
PULL DISCONNECT ARM
TO THE LEFT TO UNLATCH,
THEN PUSH IN.
PADLOCK
OPTION
HOLE
DISCONNECT ARM
(SHOWN IN DISCONNECT
POSITION).
