THINGS TO KNOW BEFORE
":ONNECTING COMPONENTS
Protect your components from power surges
• Connect all components before plugging any
power cords into the wall outlet.
• Alway s turn offtheTV andlor component
before you connect or disconnect any cables.
POSITION CABLES CORRECTLY TO
AVOID AUDIO HUM OR INTERFERENCE
Insert all cable plugs firmly into their jacks.
Place the audio/video cables to the sides of
theTV's back panel instead of straight down
the middle after you connect your
components.
Try not to coil any twin-lead cables and keep
them away from the audio/video cables as
much as possible.
Make sure all antennas and cables are
properly grounded. Refer to the SafetyTips
sheet packed with your TV.
PROTECT YOUR COMPONENTS
FROM OVERHEATING
Do not block ventilation holes in any of the
components. Arrange the components so
tlhat air can circulate freely.
Do not stack components.
Allow adequate ventilation when placing
your components in a stand.
Place an amplifier on the top shelf of the
stand so heated air rising from it will not
flow around other components.
CONNECT AUDIO/VIDEO CABLES FOR
BEST RESULTS
• Required for picture-in-picture feature
