Section 2I: Using Your Phone’s Voice Services 88
Using Quick Dial
The quick dial feature allows you to train your phone to dial
numbers in your contacts by assigning a special name to the entry.
Once the name is recorded, you can say the name and dial the
contact entry without having to repeat the entire name as saved in
the contact listing.
Quick Dial Training
Before you can use the quick dial feature, you must train the
software to recognize the entry in the contacts. To train the
software, you are required to go through the contacts and record the
desired name using your own voice. Make sure this is done in a quiet
environment to avoid outside interference.
To train quick dial:
1. Press for Start.
2. Highlight More and press .
3. Highlight More again and press .
4. Highlight Voice Signal Setup and press .
5. Press for Record Names.
6. Select the alphabetical contact range using the keypad.
7. Press down to highlight the desired contact name.
8. Press for Train.
9. Say the name clearly into the microphone.
10. Press if the recording sounded OK or to re-record
the name.
11. Press to save and exit.
