Advanced Settings and Adjustments
99
GB
Be sure to change the value in the Setup Display
when you move the speakers.
* When you perform the Quick Setup (page 29), the
default settings are changed.
Note
• When you set the distance, the sound cuts off for a
moment.
• Depending on the input stream, the [DISTANCE
(FRONT)]/[DISTANCE (SURROUND)] setting
may not be effective.
• When the speaker distance setting is not in the
recommended range, /
** m is displayed (**
being the number). indicates over the
recommended distance. indicates below.
x [LEVEL (FRONT)]
You can vary the level of front speakers as
follows. Be sure to set [TEST TONE] to [ON]
for easy adjustment.
x [LEVEL (SURROUND)]
You can vary the level of surround speakers as
follows. Be sure to set [TEST TONE] to [ON]
for easy adjustment.
To adjust the volume of all the
speakers at one time
Press VOLUME +/– on the remote or touch
VOLUME +/– (touch panel button) on the
control unit.
x [TEST TONE]
The speakers will emit a test tone to adjust
[LEVEL (FRONT)] and [LEVEL
(SURROUND)].
Adjusting the speaker level by
using the test tone
[L/R]
3.0 m
*
(appears when you set
[SURROUND] to
[YES] in the
[CONNECTION]
setting.)
Surround speaker distance
from the listening position can
be set in 0.2 meter increments
from 0.0 to 7.0 meters.
[L/R]
0.0 dB
Set this between –15.0 dB and
+10.0 dB in 1.0 dB increments.
[CENTER]
0.0 dB
(appears when you set
[CENTER] to [YES] in
the [CONNECTION]
setting.)
Set this between –15.0 dB and
+10.0 dB in 1.0 dB increments.
[SUBWOOFER]
0.0 dB
Set this between –15.0 dB and
+10.0 dB in 1.0 dB increments.
[L/R]
0.0 dB
(appears when you set
[SURROUND] to
[YES] in the
[CONNECTION]
setting.)
Set this between –15.0 dB and
+10.0 dB in 1.0 dB increments.
[OFF]
The test tone is not emitted from the
speakers.
[ON]
The test tone is emitted from each speaker
in sequence while adjusting level. When
you select one of the [SPEAKER SETUP]
items, the test tone is emitted from each
speaker in sequence.
C/X/x/c,
DISPLAY
cont
nue
