Chapter 4 Command-Line Reference 4-69
Default Setting
Shows all lines
Command Mode
Normal Exec, Privileged Exec
Example
To show the connection settings for all lines, enter this command:
4.3.7 IP Commands
By default, the switch searches for its IP address, default gateway, and netmask
using DHCP.
You can manually configure a specific IP address, or direct the device to obtain an
address from a BOOTP or DHCP server. Valid IP addresses consist of four decimal
numbers, 0 to 255, separated by periods. Anything outside this format will not be
accepted by the software.
Console#show line
Console configuration:
Password threshold: 3 times
Interactive timeout: Disabled
Silent time: Disabled
Baudrate: 9600
Databits: 8
Parity: none
Stopbits: 1
Vty configuration:
Password threshold: 3 times
Interactive timeout: 600
Console#
TABLE 4-12 IP Commands
Command Function Mode Page
IP Configuration
ip address Sets the IP address for this device IC 4-70
ip dhcp restart Submits a BOOTP or DCHP client request PE 4-71
