88
following parameters in Figure 5-24.
Figure 5-24 SNMP Settings
5.9.1 Community Setting
Selecting SNMP > Community Setting will allow you to configure the SNMP community as
shown in Figure 5-25, which is helpful for managing the access authority.
Figure 5-25 Community Setting
¾ Num - Displays the entry number of the community.
¾ Community - Defines the password used to authenticate the management station to the
device.
¾ Access Mode - This field allows you to specify the authority of the community. Read Only
means the community is only permitted to read the device configuration. Read&Write means
the community has the authority to read and change the device configuration.
¾ Status - This field allows you to enable/disable the corresponding entry.
¾ Modify - This field allows you to modify an entry.
To modify a community setting entry:
1. Find the desired entry in the table.
2. Click Modify as desired on the Modify column.
3. Modify the contact of community
4. Select the Read Only or Read&Write option in the Access Mode pull-down list.
5. Select the Enabled option in the Status pull-down list.
6. Click the Save button.
Click the Enable All button to make all entries enabled.
Click the Disable All button to make all entries disabled.
