16
STEP D-2
Lubricate a rubber O-ring by putting a drop of silicone oil on it. Push the
O-ring into the bottom of the shock body.
STEP D-3
Locate the 3x6x2.5mm spacer and remove any mold flashing. Insert the
spacer, rounded edge first, into the bottom of the shock body and press
firmly so that it compresses the rubber O-ring.
STEP D-5
Secure the seal assembly by screwing the bottom cap onto the bottom of the
shock body. Tighten the cap firmly with your fingers only. Do not use pliers
to tighten the cap.
STEP D-6
Locate the shock rods. Use needle nose pliers to insert an e-clip into the
bottom groove on each shock rod. On the two longer rods, slide a
3x6x1.5mm limiter onto each rod.
BANDIT:
Do not use the limiters in the rear shocks of the Bandit. Instead, use the limiters
in the FRONT shocks (on the shorter shock rods).
STEP D-4
Lubricate another O-ring and insert it into the bottom of the shock body, on
top of the spacer.
E-clip
3x6x1.5mm
Limiter
