19
STEP E-4
Locate the two 62mm turnbuckles (tie rods), four long rod ends, and four
hollow ball connectors. Screw the rod ends onto the turnbuckles so that each
has a center-to-center distance of 78mm. Snap the hollow ball connectors
into the rod ends.
NOTE: The turnbuckle has reverse threads on the long side. The rod end
tightens counter-clockwise on the reverse threads.
BANDIT:
The center-to-center distance should be 76mm.
STEP E-5
Fasten the tie rods to the bellcrank arms, as shown, with two 3x12mm
washerhead machine screws.
STEP E-6
Locate the upper chassis plate and two 5x8x0.5mm teflon washers.
STEP E-3
Attach the drag link to the bellcrank with the two 3x12mm shoulder bolts, as
shown. Make sure the assembly operates smoothly without binding.
STEP E-7
Turn the upper chassis plate over and slide a 5x8x0.5mm teflon washer over
each of the bellcrank pivot posts.
78mm
Reverse
threads
