25
STEP F-14
Insert the white and blue resistor wires through the square hole in the rear
shock tower. Reconnect the wires to the resistor pack. They can be
connected in any combination, so long as there is one white and one blue
wire per resistor.
FRONT BODY MOUNT:
BANDIT:
Steps F-16 through F-18 are for the Rustler only. Please skip to Step F-19.
STEP F-16
Locate the front body mount, two 25mm body posts, two 3x8mm washerhead
self-tapping screws, and two 3x10mm washerhead self-tapping screws.
STEP F-18
Fasten the body mount to the back of the front shock tower with two
3x10mm washerhead self-tapping screws.
STEP F-15
Insert the motor wires through the shock tower and
connect them to the motor (red-to-red and black-to-
black). Route the speed control cable neatly to the
receiver and plug the connector into the battery
receptacle.
STEP F-17
Fasten the body posts to the body mount with the two 3x8mm washerhead
self-tapping screws. Study the photo carefully to ensure correct assembly.
