13
SE3
SE4
English
4. SET UP
6. Stretch the main pipe and the
flexible shaft straight, thrust the
inner shaft into the main pipe while
turning it by hand, and connect the
inner shaft to the shaft of the main
pipe. Unless the end of the inner
shaft appears from the flexible
shaft, the inner shaft has been
correctly connected to the shaft of
the main pipe.
(1) Inner shaft
7. Turn the hole at the end of the
flexible shaft upward, align the
square hole of the clutch dram
with the direction of the inner
shaft, and thrust the flexible shaft
into the clutch housing until you
hear a click.
(1) Clutch housing
(2) Clutch dram square-hole
(3) Hole
After connecting the inner shaft to the
shaft of the main pipe, try to pull out
the flexible shaft by hand to make
sure the flexible shaft does not come
off.
■ ADJUSTING THE PLAY OF THE
THROTTLE WIRE
If you bend the flexible shaft, the
amount of play of the throttle wire
changes. Adjust the play while
keeping the flexible shaft almost in
the actual working condition.
(1) Flexible shaft
The play of the throttle wire that
extends out of the carburetor with the
throttle lever in its original place
should be 1 to 2 mm when lightly
pulled by finger. If the play is too
large or small, readjust it as follows.
1. Loosen the lock nut and adjust the
throttle wire with the wire brace so
that the amount of play is
appropriate. The play becomes
larger when the wire brace is
turned clockwise, and becomes
IMPORTANT
IMPORTANT
SE5
