34
English
7. MAINTENANCE
■
MAINTENANCE EVERY 100 HOURS
1. Remove the muffler, insert a
screwdriver into the vent, and wipe
off any carbon. Also, wipe off any
carbon at the muffler outlet.
(1) Screwdriver
(2) Muffler
2. Further tighten all screws, bolts
and fittings.
3. Make sure that no oil or grease
remains between the clutch lining
and the drum. If you see any
there, wipe it off using oil-free,
lead-free gasoline.
4. Remove the float chamber of the
carburetor, and clean the inside of
the float chamber.
(1) Float chamber
■ ADJUSTING THE ENGINE
Continued rotation of the blade
after the throttle lever is set to the
idling position could be
dangerous. If the blade continues
to rotate even after readjusting the
idling adjustment screw, the
throttle lever, throttle wire, or
clutch might be faulty. Contact the
shop where you bought this
product, and ask it to check and
repair the trouble.
• The idling engine speed is
adjusted when this product is
shipped from the factory, but it
might need to be readjusted
according to changes in operation
conditions (e.g. changes in the
stability of the engine, air density,
etc.). When readjustment is
necessary, try to do so as
described below. If this is difficult,
contact the shop where you
bought this product, and ask it to
implement the readjustment.
• Make sure the throttle wire is
parallel with the flexible shaft. If
the throttle wire is twisted,
straighten it.
IMPORTANT
시오. 동시에 머플러 출구의 카본도
제거해 주십시오.
2.각 조임부를 꽉 죄어 주십시오.
아 주십시오.
부를 청소해 주십시오.
험합니다. 아이들 조정나사를 재조정
주십시오.
경우가 있습니다. 조정이 필요한 경
해 주십시오.
해 주십시오. 비틀어져 있는 경우에
는 바로 잡아 주십시오.
