14
English
4. SET UP
smaller when the wire brace is
turned counterclockwise.
2. Tighten the lock nut after adjusting
the play, and fix the wire brace.
(1) Lock nut (2) Throttle wire
(3) Wire brace
■ INSTALLING DEBRIS GUARD
Do not use this machine without
the debris guard.
Fit the top of the debris guard to the
gear case, install the debris guard
on the main pipe with the accessory
clamp, and tighten the debris guard
evenly with two Phillips screws
(M5xL25).
[Tightening torque]
2.6 to 4.9 N-m (27 to 50 kgf-cm)
(1) Gear case
(2) Clamp
(3) Phillips screw (M5xL25)
(4) Main pipe
(5) Safety-guard cover
(6) Fit this part to the gear case.
■ MOUNTING THE HANDLE
1. Mount the loop handle on the main
pipe in accordance with the serial-
number label. Turn the grip and
tighten it slightly, then fasten the
hanger plate together in the
position shown in SE8.
2. Adjust the position of the loop
handle to the position where you
can work easily, and tighten the
loop handle firmly.
• Tighten the grip firmly. If the
grip becomes loose, it might
move while you are working,
causing danger.
• Do not loosen or twist the grip
while you are working.
• Always stop the engine and
make sure the blade has
stopped before adjusting the
position of the loop handle.
(1) Grip
(2) Hanger plate
어받침쇠를 고정하여 주십시오.
용하지 마십시오.
주십시오.
의 위치에 함께 조여 주십시오.
시오.
주십시오.
오.
후에 실시하여 주십시오.
