Filter
Top Products
ENGLISH
Watching a video or other
equipment
Press TV/VIDEO on the remote control or TV/
VIDEO/ENTER on the TV to display “VIDEO 1”
or “VIDEO 2” for a few seconds.
VIDEO 1: input from the VIDEO 1 INPUT AUDIO/VIDEO
jacks on the rear
VIDEO 2: input from the VIDEO 2 IN AUDIO/VIDEO
jacks on the front
Set the VCR or other equipment to playback.
To return to the TV program
Press TV/VIDEO on the remote control or TV/VIDEO/ENTER
on the TV repeatedly until the TV program appears. Also,
you can return to the TV program by selecting the channel
number directly with the number buttons.
To switch the GAME position directly
Press GAME to select the AV mode to GAME. The TV
input mode changes to VIDEO 2 automatically. And the
screen becomes to the adquate size for games.
When connecting to the AIWA VCR with
the ONE-TOUCH PLAYBACK
When ONE-TOUCH PLAYBACK or OTPB on the remote
control of VCR is pressed, this unit automatically turns on
and is in the VIDEO 1 mode. However, this function does
not operate in the following cases:
• ONE-TOUCH PLAYBACK on the VCR is pressed.
• The TV and VCR is not placed in the place where they
can receive the signal from the remote control
simultaneously.
Note
For details on how to use the VCR, consult the individual
owner’s manual for the VCR.
TV/VIDEO/ENTER
TV/VIDEO
Number buttons
GAME
1
2
19
Troubleshooting
If the unit does not seem to operate properly, read the
instructions again, then check the following guide.
There is no picture or sound.
The unit is in VIDEO input mode.
There is no sound.
Increase the volume level.
There is poor or no color.
Adjust the color setting.
The remote control does not operate.
Replace both batteries with new ones.
Clicking noise sounds.
Unavoidable expansion or contraction of cabinet due to
temperature changes. This is not a problem.
ADDITIONAL INFORMATION