Filter
Top Products
10
OPERATION - TV Tuner Control Functions
Channel Selection
3. Direct Channel Select (Numeric keypad 0 - 9)
To select the desired channel, press any of the 10 numeric keys (0 to 9) directly. These
keys are also used as the Channel Preset keys. As soon as you press a key, the number
that you selected is displayed in the OSD.
TV MODE: When you enter ‘02’ to ‘69’ (or any two digit
number), the desired channel appears immediately and the OSD
disappears in about 3 seconds.
When you enter ‘2’ to ‘9’ (or any 1 digit number), it will change
to the desired channel after a 3 second delay and the OSD
disappears in 3 seconds.
When an invalid CH (Channel) is selected, the current CH will not change and the OSD
will disappear in 3 seconds.
CABLE MODE: When you enter 001 to 125 (or any 3 digit number), the desired
channel appears immediately and the OSD disappears in about 3 seconds.
When you enter less than three digits, it will change to the desired channel after 3
seconds delay and the OSD disappears in about 3 seconds.
When an invalid CH is selected, the current CH does not change and the OSD will
disappear in 3 seconds.
4. CH DOWN/UP Key
Use the AUTO CH and MANUAL SEEK Arrow keys to select the desired TV channel.
AUTO CH DN/UP Keys
Use this key to select any CH which was set by the AUTO PROGRAM function. Press
the UP or DOWN keys to move up or down in sequential order.
MANUAL SEEK DN/UP Key
This key has two functions as follows.
• Press and release: Channel moves UP or DOWN one frequency at a time (whether
a station exists or not).
• Press and Hold: Press and hold the UP or DOWN key for at least 2 seconds to
seek up or down to the next valid station.
NOTE:
If the tuner does not find a valid CH during the seek mode, it will stop after all channels have been
checked.
_
_ CH 24