Filter
Top Products
Architect & Engineer Specification
8200-2608-01 B0 VideoEdge
®
Network Video Recorder 19 of 20
AMERICAN DYNAMICS
V
IDEOEDGE
TM
NETWORK VIDEO RECORDER
SABS (South Africa) Class B
CCC (China) Class B
MIC (Korea) Class B
Safety ............................................... UL 60950
CAN/CSA C22.2 No. 60950
EN 60950
IEC 60950
PART 3 – EXECUTION
3.01 EXAMINATION
A. Submission of a proposal confirms that the contract documents and site conditions
are accepted without qualifications unless exceptions are specifically noted.
B. The site shall be visited on a regular basis to appraise ongoing progress of other
trades and contractors, make allowances for all ongoing work, and coordinate the
requirements of this contract in a timely manner.
C. The Network Video Recorder must be inspected before installation, and shall be free
of any cosmetic defects or damage.
3.02 PREPARATION
A. Prior to installation, the Network Video Recorder shall be configured and tested in
accordance with the manufacturer’s instructions.
3.03 INSTALLATION
A. The Network Video Recorder must be installed, programmed, and tested in
accordance with the manufacturer’s instructions.
1. In order to ensure a complete, functional Network Video Recorder, for bidding
purposes, where information is not available from the Owner upon request, the
worst-case condition shall be assumed.
2. Interfaces shall be coordinated with the Owner’s representative, where
appropriate.
3. All necessary backboxes, racks, connectors, supports, conduit, cable, and wire
must be furnished and installed to provide a complete and reliable Network
Video Recorder installation. Exact location of all boxes, conduit, and wiring runs
shall be presented to the Owner for approval in advance of any installation.
4. All conduit, cable, and wire shall be installed parallel and square with building
lines, including raised floor areas. Conduit fill shall not exceed forty percent
(40%). All wires shall be gathered and tied up to create an orderly installation.