Filter
Top Products
18
FAQ - Frequently Asked Questions
Q: Why doesn’t the LCD TV turn on?
A: Check the AC power adapter to make sure it is securely connected to
the DC-in power jack at the rear of the LCD TV. Make sure the power
cord is plugged into a functioning electrical outlet.
Q: Why is the power LED on but the screen is blank?
A: Make sure the video cable is securely connected to both the LCD TV
and the device you have attached. Also, make sure you have correctly
connected all of the cables required for your device. Refer to the user’s
manual that came with your equipment for further information.
Q: Why is my TV too dark or too bright?
A: You can adjust the brightness of the LCD screen. Refer to “Adjusting
the Display” on page 13.
Q: Why is there no sound coming from the speakers?
Check your audio cables to make sure they are connected properly.
Also, make sure the mute is turned off. Finally, check the sound mode
by press the MTS key on the remote control to switch between SAP,
Mono and Stereo. Press the Display key to view the setting on the
screen.
Q: Why is the LCD TV blurred when I connect it to my PC?
A: The LCD TV supports VGA (640x480) video mode. Make sure the TV
settings of your computer are adjusted to this setting. Setting your com-
puter’s TV resolution to a higher resolution will result in a poor quality
image or no picture at all.
Q: Why can’t I view any TV channels?
A: You must scan for channels before you can view TV channels. For
more information, see page 15.
Q: Why is my reception bad when watching TV?
A: This could be a variety of reasons, including local interference, if using
an over-the-air antenna. Make sure you use a coaxial cable for TV input.
Make sure the connection is secure, and grounded. (You may need an
electrician to check this for you.) Reception is best from cable TV, satel-
lite dish, or a high-powered rooftop antenna.
Q: Why is the screen too light/dark when in VGA mode?
A: You may need to adjust the white balance. See “White Balance” on
page 14. Also, try adjusting the brightness. You can also find this on
page 14.
Q: How do I adjust the “tilt”, or angle, of my LCD TV?
A:You can adjust the LCD display viewing angle from an upright position
to a back-tilted angle of up to 7 degrees and a forward-tilted angle of 4
degrees. When tilting the screen, hold the base firmly and adjust the
viewing angle by moving the top of the display forward or backward. Do
not press the LCD panel when tilting the display. (See picture A, below.)
WARNING - Forcing the LCD TV past its maximum extension point will
damage the unit.
Q: How do I mount my LCD TV to the wall?
A: You will need to purchase a standard wall mount kit (100 mm x 100
mm screw mount area, minimum 35 kg load-carrying weight) from your
local retailer if you want to attach the LCD TV to a wall or other fixed sur-
face. First, prepare a flat, stable working area with a soft cloth or foam
pad to place the LCD TV on. Next, turn the LCD TV power off, discon-
nect it from the power adapter, and gently lay the display on its front
(screen side.) Third. remove the four screws located at the rear of the
LCD TV as illustrated in picture B, above. Remove the LCD TV display
stand. For final attachment and hanging, refer to and follow the instruc-
tions included with the wall mount kit that you purchased.
Q: If I have more questions, where should I go?
A: Try the Customer Support section of www.apexdigitalinc.com. There
are many more Frequently Asked Questions there, as well as many
other helpful options.
A
B