Filter
Top Products
28
TROUBLESHOOTING GUIDE
Check the following guide for a possible correction to a problem before contacting customer service.Check
FAQ at our website: www.apexdigitalinc.com.
Symptoms and Correction
Symptoms Correction
No power
No picture
No sound
No TV signal
Stripe or purple interfe-
rence appears in the
screen.
Picture with multi-image
Picture becomes
snowy.
No stereo or foreign
language received
TV channel not received
Black box appears on
screen.
Remote control
doesn't operate.
Connect the power plug into the wall outlet securely.
Verify the connection from the DVD/VCR video output to the TV video input is
secure.Then switch TV to the appropriate Video mode.
Verify coaxial cable from antenna is connected to RF IN.
Connect the audio cables into the terminals securely.
Verify the connection from the DVD/VCR audio output to the TV autio input.
Then switch to the appropriate mode on the receiver. Refer to your audio amp-
lifier owner's manual.
Mute feature may be enabled.
Make sure MTS feature is properly set.
Check whether your receiver is set to the TV mode.
Check whether the antenna is well connected to the TV receiver.
Unplug the TV from the wall for 30 seconds, then plug in and try again.
Unplug the antenna connection from the back of the TV, unplug the TV from the
wall, wait 30 seconds, then try again.
Interference may come from high frequency sources such as a broadcasting
station, poor ground connection in cable used, or non shielded audio speakers
too close to the picture tube.
Check the antenna lead wire to see if it has open circuit or not.
Check the connection of antenna lead wire to the TV set input.
Check whether there is any damage to antenna.
Change the direction of antenna to minimize the multi image.
The video frequency radiated from TV station can be reflected by tall buildings,
high tower, etc.
Make sure the Air/Cable setting is correct.
Channel may be locked with the block channel feature, such as Parental Control.
Check Add/Erase feature, as channel may have been erased during set up.
Make sure MTS feature is properly set.
Closed Caption to Text feature may be active.
Batteries may be weak. Replace batteries.
Make sure remote sensor is not blocked including deflection from curved glass
cabinet.
Program the remote contrpl to 000 for your TV. See “Prgramming the Remote
Control”