Filter
Top Products
U
se the following procedure to program the Wireless Keychain Remote
c
ontrol button to a SCENE button on the Wireless Gateway, RFBGD.
This procedure also is used to reassign a transmitter button to a different
SCENE button.
1
. Press and Hold SCENE button you wish to program, either Scene 1,
2
or 3, until the LED turns off, then immediately release the SCENE button.
2. Press and hold the desired Keychain Remote Control button.
The LED on the Wireless Gateway will flash three (3) times quickly to
i
ndicate the programming is successful.
3
. Release the transmitter button.
N
ote: Your Keychain Remote cannot directly operate Z-Wave™
modules, the Z-Wave™ modules must be programmed to the Gateway
Scene to which you have programmed your transmitter button.
4. To OPERATE, plug the Wireless Gateway into AC power, then press the
t
ransmitter button corresponding to the programmed SCENE which you
want to activate.
Best Practice Tip: Program the garage door opener to a button by itself
and SCENE’s to their own transmitter buttons.
Use the following procedure to program the Wireless Keychain Remote
control button to a ASPIRE RF Garage Door Opener Conversion Module,
Model RFUGR. This module will allow your Keychain Remote Control to
operate any brand Garage Door Opener.
1. Install the Garage Door Opener Conversion Module per the
instructions provided with it.
2. Press and release the PROGRAM button on the Conversion Module.
The red indicator will turn on.
3. Press and release the desired transmitter button.
The Red LED indicator will flash to indicate as successful operation.
6. To OPERATE, press the transmitter button corresponding to the
Conversion module.
4. Release the transmitter button.
4
Examples Of Scenes
The following examples describe how
your Wireless Gateway can be used.
For further ideas, please visit our website at
www.cooperwiringdevices.com/ASPIRERF.
1. Approaching your home in your car, you wish
to turn on the outside lights near the garage, front
door and rear door, as well as a lamps in the
kitchen and family room. Wireless Gateway
SCENE 1 can be programmed to turn all of these
lights ON. To operate SCENE 1 from your car, you
will also need to program one button of the
remote located in your car to SCENE 1.
Examples require the following modules:
1 - Wireless Gateway, RFBGD
1 - Keychain Remote, (RFKGT) or any
built-in vehicular remote control
3 - Dimmer Switch, RF9534
(for each light switch)
2 - Lamp Module, RFLDM
for lamp in kitchen and family room)
L
ED’s
C
hoose 1
SCENE
Button
T
ransmitter
Buttons
Program Button
Transmitter
Buttons
Red
Indicator
Helpful Hint: A broom handle
can be used to extend your
reach for depressing the
program button.
Programming To Controller
Programming To Conversion Module