Filter
Top Products
Troubleshooting
P
roblem:
One of my Wireless Gateway SCENES is not
w
orking.
Problem:
My operator no longer works with my remote.
S
olution:
The Cooper Wiring Devices Wireless Gateway can
be activated by up to 12 transmitter programs.
When exceeded the last one programmed will
b
e dropped.
Solution:
The Wayne Dalton operator can be activated by
u
p to six remote control devices (including wall
s
tation and keyless entry controls). If a seventh
control is programmed, one of the programmed
controls will be overwritten and will no longer
activate the operator. To clear the programming
o
f all remote control devices, press and hold the
DoorMaster™ light fixture program button, idrive®,
Quantum™ or Classic drive™ operator program
b
utton for approximately ten seconds. When the
DoorMaster™, Quantum™, Classic drive™ status
LED goes out or idrive® operator beeps three
times, then all controls
are erased.
Covered by one or more of the following Wayne Dalton Patents D413,055; D413,579; D413,867; D421,031;
D472,568; D472,910; D473,573; D473,574; D505,393; 5,929,580; 5,931,212; 6,078,249; 6,161,438; 6,145,570; 6,164,014;
6,325,134; 6,326,751; 6,326,754; 6,401,792; 6,561,255; 6,561,256; 6,568,454; 6,588,156; 6,605,910; 6,667,591; 6,739,372;
6,845,804; 6,851,465; 6,873,127; 6,880,609; 6,903,650. Other US and Foreign Patents pending.
Z-Wave™ is a trademark of Zensys Corp.
FCC and IC Statement
FCC Regulatory Information:
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try and correct
the interference by one or more of the following measures:
a) reorient or relocate the receiving antenna,
b) increase the separation between the equipment and receiver,
c) connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
IC Regulatory Information:
This Class B digital apparatus meets all requirements of the Canadian Interference Causing Equipment
Regulations. Operation is subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation of the device.
WARNING: Changes or modifications to this receiver not expressly approved by Cooper Wiring Devices
could void the user’s authority to operate this equipment.
Compliance