Filter
Top Products
5
Examples Of Scenes
2
. In your car and leaving your home you wish to
turn off the outside lights near the garage, front
d
oor and rear door, as well as interior lights and
a
ppliances. Wireless Gateway SCENE 2 can be
programmed to turn all of these modules OFF and
to turn ON the security alarm. To operate SCENE
2
from your car, you will also need to program
o
ne button of the remote located in your car to
SCENE 2.
3
. Noises outside your home awaken you during
the night. SCENE 3 is programmed to turn on only
t
he outside lights. You can turn on SCENE 3 with
your Keychain Remote from your bedroom to
i
lluminate the area and scaring off any potential
intruders.
4. Lights out! You have tucked your 2 children in
bed and one has your permission to read for 15
minutes while the other has your permission to
watch TV for 15 minutes. After 15 minutes you
want to turn off their lights and TV. SCENE 2 is
programmed to their bedroom lights, lamps and
to a TV in the childs room. Using your Keychain
Remote you can turn their lights and TV off.
1
- Wireless Gateway, RFBGD
1
- Keychain Remote, (RFKGT) or any
built-in vehicular remote control
3 - Dimmer Switch, RF9534
(for each light switch)
2
- Lamp Module, RFLDM
(
for lamp in kitchen and family room)
1 - Wireless Gateway, RFBGD
1
- Keychain Remote, RFKGT
3 - Dimmer Switch, RF9534
(for each light switch)
2
- Switches, RF9501
(for exterior lights)
1 - Wireless Gateway, RFBGD
1 - Keychain Remote, RFKGT
2 - Dimmer Switch, RF9534
(for each light switch)
2 - Lamp Module, RFLDM
(for lamp in kitchen and family room)
1 - Appliance Module, RFAPM (for the TV)
Use this procedure to program your Keychain Remote for up to 6 actions.
In any of the previous programming instructions at the point where you
need to activate a transmitter button to complete the programming
step, simply simultaneously press a combination of any two buttons.
Then to activate that programmed action, simultaneously press those
two buttons.
Example of Use: Single Big button is programmed only to activate
Garage Door Opener, while each of the two smaller buttons are
programmed to SCENE 1 and 2 of the Gateway Module. SCENE 3
of the Gateway module can be programmed to activate by pressing
the two smaller buttons at the same time.
Troubleshooting
Problem:
The range of the transmitter is reduced.
Problem:
The LED (light) on the transmitter does not turn
on when pressed.
Solution:
Replace Battery.
Solution:
To change the batteries,
insert a coin in the coin
slot and twist to access
the battery compartment.
Your transmitter may use
one or two CR2016
batteries. Remove the
batteries from the battery
cage and replace with fresh batteries.
Be sure to maintain the correct polarity (+).
Press two transmitter
buttons at the same time
Coin Slot
Button Combinations