Filter
Top Products
14
Connecting the TV55 to a TV
1. Run the RG6 coaxial cable from the antenna towards your
television set and connect the RG6 coaxial cable to the supplied
Power Injector on the terminal labeled “TO ANTENNA”.
2. Connect the “TO TV” lead on the power injector to the “ANT IN”
on your TV.
3. Plug the Power Adapter from the Power Injector into a standard
AC outlet. Switch the Power Injector “ON” for amplification.
See Fig 14.
Splitting the Signal to Multiple TV’s
Follow the diagram to use the
TV55 with more than one TV.
A splitter will be required
sold separately).
NOTE: The Power Injector
MUST be installed between
the TV55 and the splitter.
Failure to do so could cause
a short circuit. The Power
Injector should always be
located indoors.
TV55
Fig 14.
TO TV
BSP-2
TO TV 1
T
O TV 2
TO TV55
Splitter (such as the
Terk BSP-2)