Filter
Top Products
Chapter 2 Hardware Installation and Setup
9
Connecting the TV
To display the slide presentation on TV (or any video monitor), you’ll need to
connect the TV to one of the ports at D-side panel of AVerEPack300.
If the TV set uses the composite video standard, connect the TV to the D-side
panel of AVerEPack300 “VIDEO” port using the supplied AV Cable.
If the TV set uses the S-Video standard, connect the TV to the D-side panel of
AVerEPack300 “S-VIDEO” port using the supplied S-Video Cable.
Set the DIP switch no. 2 to TV mode then from DIP switch no. 1 switch the
proper TV system you have. The DIP switch is located at the C-side panel of
AVerEPack300 unit beside the “Power” port. If you are not sure of your TV
system, please refer to your TV manual.
AVerEPack300 D-Side Panel
Rear of TV
S-IN
V
IDEO-IN
S-Video Cable
(supplied)
AV Cable
(supplied)
D
C
B
A
12
O
N
DIP SWITCH - PAL TV SYSTEM
12
O
N
DIP SWITCH - NTSC TV SYSTEM