Filter
Top Products
12
Chapter 2 Operating the EB DVR System
2.1 Using the EB DVR System for the First Time
Upon connecting the power, the unit automatically detects the status of the hard
disk. The hard disk must be formatted for the first time installed on DVR system. If
you are prompt to format the hard disk, press (select) for
YES
to format the
hard disk and (menu) for
NO
to remain unchanged.
HARD DISKS INFORMATION
VERSION 1 . 5. 03
MASTER HDD
HDD FORMAT YES (SELECT) / NO (MENU)
HDD CHECKING . . .
SIZE 76GB 509MB
2.1.1 Set up the System Date and Time
1. Press to call up the OSD menu and then use
▲
and
▼
or
and to go up and down and select
SUBMENU
. And then, press or
▲
to confirm the selection.
2. In Submenu, select the
DATE
and press again to make a selection. And
then, use
▲
and
▼
or and to adjust the date and use
▼
▼
and
▼
▼
buttons to move the selection to the left and right.
3. To adjust Time, follow the above step 2 and 3.
4. Press
to go back to main menu after adjustment.
2.2 Surveillance Screen
User can switch to display each channel in full screen or 4 channels at the same
time in D1 or CIF record mode.
To know if the channel is being recorded, the “ ” record symbol would appear
beside the channel number. The (microphone) and (speaker) indicate the
availability of audio. The information below the screen shows the current date and
time, recording mode (record schedule setting), hard disk drive (Master/Slave) and
the percentage of the used hard disk space.