Barco R5900001/02 DVR User Manual


 
2. Introduction to ClickShare
2 1 3 2
Image 2-3
TheBaseUnit
1 USB port
2 Status LED strip
3 Standby Button
Table 2-3
USB Port
The USB port is used to update the software of both the Base Unit and the B uttons.
When plugging in the Button into the Base Unit, the Button is paired to the Bas e Unit. The Base Unit checks whether the software
and rmware of the B utton is up to date. If not, the B ase Unit updates the software and/or rmware.
Status LED strips
The c olor of the LEDs at the front of the Base Unit give information on the status of the system.
LEDs behavior Explanation
static red
receiving content from the Buttons and streaming towards the display.
pairing and software update of the Button is done. You can now unplug the
Button from the Base Unit.
during the rst phase of the Base Unit boot process.
blinking white
system is starting up (during the second phase)
Button pairing is in progress
software update of the Base Unit
slow blinking white
standby mode (i.e. muting the display output)
static white
awake and ready (i.e. showing the welcome message on the display)
pairing is done
red blinking
an error occ u rred
Standby button
The b utton at the front of the Base Unit has a power on/off function and a standby function.
When the system is awake, a short push triggers the system to go into standby mode.
When the system is in standby mode, a short push triggers the system to wake up.
When the s ystem is powered on, a long push makes the system to shut down and power off.
When the system is shut down, a long pu
sh or short push triggers the system to s tart up.
R5900001 CLICKSHARE 08/07/2013
7