Filter
Top Products
Hardware Overview
Manual Documentation Number: PES1A/PESV1A-2907m 7
B&B Electronics Mfg Co Inc – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104 – www.bb-elec.com
B&B Electronics Ltd – Westlink Commercial Park – Oranmore, Galway, Ireland – Ph +353 91-792444 – Fax +353 91-792445 – www.bb-europe.com
Ethernet Port Connector
The Ethernet Port connector is a standard RJ-45 receptacle that allows the
serial server to be connected to an Ethernet network. It also carries Power
over Ethernet (PoE) based on the IEEE 802.3af standard.
On the PES1A/ PESV1A two indicator LEDs are built into the RJ-45
connector.
Serial Port Connector
The Serial Port Connector is a DB-9 male connector (configured as a DTE)
supporting RS-232 serial communications including TD, RD, TRS, CTS,
DTR, DCD, DSR and GND signal lines. Use a standard serial cable if
connecting to a DCE; use a null modem (crossover) cable if connecting to a
DTE.
Refer to Appendices D, E and F for connection pin-outs.
Power Connector
Power is supplied to the PES1A/PESV1A by PoE (Power over Ethernet) via
the RJ-45 Ethernet receptacle. Power over Ethernet may be delivered via un-
used pairs in the CAT-5 cable, or via a simplexed power technique. Both
options are supported by the PES1A and PESV1A. PoE power consumption
for the PES1A and PESV1A are rated Class 3.
Refer to Appendix E for Ethernet connection pin-outs and additional information
on PoE.
Output Power Connector (PESV1A only)
The output power connector (on the PESV1A only) is a two position
removable terminal block that provides a DC power supply voltage output
(derived from the PoE input power) in three selectable ranges: 5 VDC, 9
VDC and 12 VDC. Maximum output power is 4 watts.
Figure 5. Side View of the PESV1A