Filter
Top Products
10
6 Performing the initial power-on settings
PR 01
PR 11
PR 01
MENU
MAIN MENU
PICTURE
SOUND
PROGRAM TABLE
SETUP
FEATURES
SELECT
EXIT
6.1-TV controls
6.1.1-Temporary on/off (STAND-BY)
When you press the red STANDBY
button on your remote control while
your television is switched on, the
sound and the picture will go off.
In the stand-by mode, the power
indicator of your television will glow
brighter. To switch your television
back on, either press any numeric button or
PR+/PR- buttons.
Caution! If you are not going to use your
television for a long time, unplug its power
cable from the socket.
6.1.2-Program selection
You may switch to the previous or
next program by pressing the P-/P+
buttons located on your television and
your remote control. You may enter
the number of the program you would
like to select using the numerical
buttons. For example, to switch
to the program number 12, press
respectively the numeric buttons 1
and 2 on your remote control. You
can perform the program selection
also from the Program Table. See page 9 for
the program table.
6.1.3-Digital TV, Analogue TV and AV
Mode Selection
Press the AV button on your
remote control. SOURCE menu
will be displayed. Select DIGITAL,
ANALOGUE or desired AV mode
with Up/Down movement buttons
and confirm with OK button so that
your television will switch to the
source you have selected.
6.1.4-Temporary sound mute (MUTE)
To temporarily mute the sound of
your television, press the MUTE
button on your remote control. In
that case, MUTE symbol will appear
on the screen. When you press the
same button a second time, the sound will
be restored. If you press the VOL+ button
while in the Mute mode, the sound level is
increased and the Mute function is aborted.
6.1.5-Returning to Selected Program
(SWAP)
Allows you to switch between the
current program you watch and the
last selected program. For example,
if you change the channel to Program
11 while you were watching Program 1, press
SWAP button to switch back to Program
1. Press SWAP button to switch back to
Program 11 again.
6.1.6-Main Menu
Press the MENU button. The Menu
including all the setting menus will
appear on the screen. Navigate
through the Menu titles with the Up /
Down movement buttons and press
the OK button to select the desired
menu. If you want to exit the menu
in any step, or return to the previous
menu while you are in a sub menu,
just press the BACK or MENU button.