Filter
Top Products
22
9.2.3-PC Setting
Enter into the SETUP menu from the Main
Menu by pressing the MENU button in the
PC mode. In order to make the necessary
settings in this menu, you can use the P+/P-
/ -VOL/VOL+ movement buttons on your
remote control. You can make the following
settings for your monitor in this menu.
9.2.4-HORIZONTAL POSITION:
Horizontal position setting
9.2.5-VERTICAL POSITION: Vertical
position setting
9.2.6-CLOCK
This is the pixel clock frequency. User can
narrow down or enlarge the display by
selecting a desired value.
9.3-Connecting a video recorder device and a digital satellite
receiver
DIGITAL SATALLITE RECEIVER
VIDEO RECORDER
REAR OF THE TELEVISION
Scart 1 TV IN/OUT
Scart 2 AUX IN
ANT IN
ANT OUT
ANT IN ANT OUT
ANT IN
SCART Socket
SCART socket
9.2.7-PHASE
Using the -VOL/VOL+ movement buttons,
you can ensure that the colors and shapes
are exactly consolidated on the PC image.
9.2.8-AUTOCONFIGURATION
The most suitable geometric settings
in accordance with the entry mode are
configured by this function. For this operation,
select the AUTOCONFIGURATION tab and
press OK button. You can adjust the volume
level of the source you have connected to the
Audio-In input at the back of your TV by using
the -VOL/VOL+ buttons.
Note: In the Monitor mode, you can make the
Brightness, Contrast, Sharpness, Red, Green
and Blue Settings from the PICTURE menu.
10 Help and tips
The television does not function
Make sure that the power cable of the
television is connected to the mains and the
power on-off switch is turned on.
Poor picture quality
• Is the aerial cable connected?
• If you are using a satellite aerial, has the
aerial been adjusted to receive broadcast
in the best way?
• Make sure that the aerial is far from
devices that emit electromagnetic waves.
(Neon lights, loudspeakers etc.)
• Try changing the direction of the external
aerial. High buildings and mountains
can cause a faded picture or ghosting
(double picture).
• The picture quality can be affected when
two external devices are connected. Try
disconnecting one of the devices.
• Try adjusting the fine tuning.
No picture
• Is the aerial connected correctly?
• Is there any damage to the aerial cable?
• Are the plugs on the aerial cable
connected correctly?
• Are you sure that you have pressed the
correct button on the remote control?
No sound