Beko 15LB250MID Flat Panel Television User Manual


 
7
Note 1: Your TV will switch to the stand-by
mode in five minutes if there is no broadcast
signal from aerial.
3. To power on your television, press any
numerical key or P+ or P- keys on the
remote control.
Note: If you are not going to use your
television for a long time, unplug its power
cable from the socket.
4 Start
Remove your television carefully from its
box. You can keep the packaging of your
television to use in future.
Items supplied with your television
Mains lead (*)
Adaptor (*)
Remote control
2 batteries
Note: The Scart, VGA (*) and PHONO
cables are not supplied with the
device.
(*) These features are optional and may not
be available on all models.
4.1-Aerial connection
If you use a 75 Ohm coaxial cable (round
cable) as an aerial cable, connect the aerial
plug directly to the aerial input located on
the TV.
Motorized vehicles, energy lines and
telecommunication lines affect your aerial.
Therefore, be careful to install your aerial
away from these and metal surface in such
a way that it shall not move. Do not make
your aerial cable longer than required and do
not coil it. Make sure that it is not crimped
passing through a window or door. Your
aerial and cable might be affected by natural
phenomena such as rain, wind, smoke and
humidity over time. Periodically check your
aerial and equipment.
4.2-Powering on your device
and the initial use
1. Insert the mains lead or the adaptor into
the appropriate power supply input located
on the back panel of the LCD TV.
2. Insert the plug of the mains lead or
adaptor, supplied with the TV into the mains
socket.
Initial power on and performing
settings
To set up your television, read the sections
on the TV controls and making the channel
settings.
4.3-Batteries
Open the lid of the battery compartment
and make sure that you have placed the
batteries in the correct direction. For this
remote control, UM-4, IEC R03 or AAA 1.5 V
batteries are suitable.
Do not throw your old batteries into the fire,
discard them in a dedicated waste area for
this purpose.
Do not mix used batteries with new ones or
different types of batteries together.
The performance of the remote control will
be reduced at a distance of 8 meters from or
at an angle of 30 degrees beyond the centre
of the TV.