Filter
Top Products
10
6
Performing the initial power-on settings
6.1-TV controls
6.1.1-Temporary on/off (STAND-BY)
When you press the red STANDBY
button located on your remote control
while your television is switched on,
the sound and the picture will go off.
In the stand-by mode, the power
indicator of your television will glow
brighter. To switch your television
back on, either press any numeric button or
P+/P- buttons.
Caution! If you are not going to use your
television for a long time, unplug its
powercablefromthesocket.
6.1.2-Digital TV, Analogue TV and AV
Mode selection
Press the Source button on your remote
control. SOURCE menu will be displayed.
Select DTV(Digital TV), ATV (Analogue TV) or
desired AV mode from the Source menu with
up/down movement buttons and confirm
with OK button so that your television will
switch to the source you have selected.
6.1.3-Channel Selection
You may select program number you would
like by pressing the P+/P- buttons on your
television and on your remote control. To
select the programs that are above 9, you
can use the Numerical buttons. You may
enter the number of the program you would
like to select using the numerical buttons. For
example, to switch to the program number
12, press the numeric buttons 1 and 2 on
your remote control. You can perform the
program selection also from the Program
Table and Channel List menus.
6.1.4-Temporary sound mute (MUTE)
To temporarily mute the sound of your
television, press the MUTE button
on your remote control. The MUTE
symbol will appear on the screen.
When you press the same button
a second time, the sound will be
restored. If you press the VOL+ button while
in the Mute mode, the sound level is increased
and the Mute function is aborted.
6.1.5-Returning to the Last Viewed
Program (SWAP)
Allows you to switch between the
current program you are watching
and the source, or the last selected
program and the source. For example, if you
change the channel to Program 11 while
you were watching Program 1, press SWAP
button to switch back to Program 1. Press
SWAP button to switch back to Program 11
again.
6.1.6-Main Menu
Press the MENU button. The Menu including
all the setting menus will appear on the
screen. Navigate through the Menu titles with
the Right/Left movement buttons and press
the OK button to select the desired menu.
If you want to exit the menu in any step,
just press the EXIT button. Press BACK
or MENU buttons to return to the previous
Menu while you are in a sub menu.