Filter
Top Products
27
Connecting external equipment
Headphones (Model Dependant)
The headphones must have an impedance of between 8 and 32 ohms and have a 3.5 mm
stereo jack plug.
Plug the headphone jack into the headphone socket of the TV.
To activate headphone sound, press the mute “
” button on the remote control (a mute
symbol will appear on the screen) and adjust headphone volume by using the VOL+ on
VOL- buttons on the remote control or front panel of the television.
Connecting a video recorder
Via SCART
Make sure the TV and video recorder are both switched off.
Plug one end of the SCART lead (not supplied) into the back of the video recorder and the
other end into one of the SCART sockets on the back of the TV. Switch on the video recorder
and the TV.
Press the
»
AV
« button on the remote control to select AV1, AV2 or AV3 (Model dependant)
to
correspond with SCART socket you
are using on the back of the TV.
Please note:
You can connect a RGB external equipment via Scart 1. It is necessary to you use full
Scart cable for this purpose.
Select the video outputs of external device by using its menu to RGB if it’s available.
Via PHONO lead (Not supplied)
Make sure the TV and video recorder are both switched off.
Plug one end of the PHONO lead into the video and audio out sockets on the back of the
video recorder and plug the other end into the video and audio in sockets of the TV.
If the sound is in mono use the Audio Input L. In the SOUND menu select MONO.
Press the
»
AV
« button repetitively and select the AV3 mode for two scart models or select
AV4 mode for three scart models.