Filter
Top Products
Controls and Displays
03
2152
En
18 MULTI DIAL
Use for scanning and slow motion control.
19 Jog indcator
Lights when multi dial is in jog mode .
20 JOG (JOG MODE)
Press to put switch jog mode on/off. When
on, use the MULTI DIAL to advance or
reverse frames.
21 FL (DIMMER)
Press to change the display brightness
22 8
Press to pause playback; press again to
restart
23 1 and
/e
/ ¡ and
E/
Use for reverse / forward slow motion
playback, frame reverse / advance and
reverse / forward scanning.
24 SURROUND
Press to activate/switch off 2V/TruSurround.
25 CLEAR
Press to clear a numeric entry
26 ENTER
Press to select an option or execute a
command
27 TV CONTROL buttons
VOLUME
Use to adjust the volume
CHANNEL
Use to select TV channel
FUNC
Press FUNC to select the TV for remote
control operation
28
TV
Press
TV to turn the TV’s power on or put
in to standby
Setting up the Remote Control to
TV
This most be set to use buttons 27 and 28.
1. Input the Manufacturer code.
While holiding down the CLEAR button,
input the two digit code from the table next
page that corresponds to the make of your
TV.
For example, If you have a Pioneer TV, press
and hold CLEAR, then press 0, 0 on the
remote control.
2. Confirm that the TV is responding to
the programmed code.
On the remote, press the
TV button. If the
TV swithches on (or into standby if it was on
previously), then you have the correct code.
If nothing happens when you press the
TV
button, start again from step 1 using a
different code.
• Some manufacturers have several
codes. Try each one until you find the
one that works.
Preset code list
00, PIONEER1
01, RCA1
02, SHARP3
03, ZENITH1
04, SONY
05, TOSHIBA1
06, HITACHI1
07, PHILIPS
08, PANASONIC1
09, MITSUBISHI
10, GOLDSTAR1
11, GE1
12, MAGNAVOX1
13, JVC1
14, SANYO2
15, RCA2
16, RCA3
17, RCA4
18, RCA5
19, SHARP1
20, ZENITH12
21, SANYO1
22, PANASONIC2
23, GOLDSTAR2
24, HITACHI2
25, HITACHI3
26, TOSHIBA2
27, SHARP2
28, GE2
29, MAGNAVOX2
30, TOSHIBA3
31, HITACHI4
32, JVC2
33, FUJITSU
34, PIONEER2
35, GRANDIENTE
1
7
13