6 en | Safety Digital Video Recorder
F01U | 2.0 | 2008.12 User Manual Bosch Security Systems
Moving - Disconnect the power before moving the unit. Move the unit with care. Excessive force or
shock may damage the unit and the hard disk drives.
Outdoor signals - The installation for outdoor signals, especially regarding clearance from power
and lightning conductors and transient protection, must be in accordance with NEC725 and NEC800
(CEC Rule 16-224 and CEC Section 60).
Permanently connected equipment - Incorporate a readily accessible disconnect device in the build-
ing installation wiring.
Pluggable equipment - Install the socket outlet near the equipment so it is easily accessible.
Power disconnect - Units have power supplied whenever the power cord is inserted into the power
source. The power cord is the main power disconnect for all units.
Rack-mount
– Ventilation - Do not place this unit in a built-in installation or rack without proper ventilation
or adhering to the manufacturer’s instructions. The equipment must not exceed its maximum
operating temperature requirements.
– Mechanical loading - Properly mount the equipment in a rack to prevent a hazardous condi-
tion due to uneven mechanical loading.
SELV - All the input/output ports are Safety Extra Low Voltage (SELV) circuits. SELV circuits should
only be connected to other SELV circuits.
Video loss - Video loss is inherent to digital video recording; therefore, Bosch Security Systems can-
not be held liable for any damage that results from missing video information. To minimize the risk
of lost digital information, Bosch Security Systems recommends multiple, redundant recording sys-
tems, and a procedure to back up all analog and digital information.
FCC & ICES Information (residential applications)
(U.S.A. and Canadian Models Only)
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that inter-
ference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
– reorient or relocate the receiving antenna;
– increase the separation between the equipment and receiver;
– connect the equipment into an outlet on a circuit different from that to which the receiver is
connected;
– consult the dealer or an experienced radio/TV technician for help.
Intentional or unintentional modifications, not expressly approved by the party responsible for com-
pliance, shall not be made. Any such modifications could void the user’s authority to operate the
equipment. If necessary, the user should consult the dealer or an experienced radio/television tech-
nician for corrective action.
The user may find the following booklet, prepared by the Federal Communications Commission,
helpful: How to Identify and Resolve Radio-TV Interference Problems. This booklet is available from the
U.S. Government Printing Office, Washington, DC 20402, Stock No. 004-000-00345-4.
Disclaimer
Underwriter Laboratories Inc. (“UL”) has not tested the performance or reliability of the security or
signaling aspects of this product. UL has only tested fire, shock and/or casualty hazards as outlined
in UL’s Standard(s) for Safety for Information Technology Equipment, UL 60950-1. UL Certification does
not cover the performance or reliability of the security or signaling aspects of this product.
UL MAKES NO REPRESENTATIONS, WARRANTIES, OR CERTIFICATIONS WHATSOEVER REGARDING
THE PERFORMANCE OR RELIABILITY OF ANY SECURITY OR SIGNALING-RELATED FUNCTIONS OF
THIS PRODUCT.
Copyright
This user guide is the intellectual property of Bosch Security Systems and is protected by copyright.
All rights reserved.