Filter
Top Products
10
SYSTEM CONTROLS
S
YSTEM CONTROLS
EnglishFrançais Español
Selection adjustment
Seek backward or forward to the next CD track or strong radio station. Or
display the motion rate control bar on your TV screen during DVD play.
Skip backward or forward to the next CD track, DVD chapter, radio
preset, or TV channel.
Raise or lower the volume of the current source.
Pressing
+
unmutes the source playing (if muted) in the current room only.
Pressing
–
lowers the volume.
Play options
With the exception of Shuffle and Repeat, the buttons below work with your VCR or DVR after
the remote has been set to control that component.
Stops the disc player.
For DVDs and VCDs only, the system bookmarks where the disc stopped, so you
can resume play there. Pressing again clears the bookmark.
Pauses the disc player.
Starts the disc player.
Skip back or forward to the start of a track or chapter. Or display the
motion rate control bar on your TV screen during DVD play.
When pressed and held, scan backward or forward through the current CD
or MP3 disc.
Plays CD tracks in random order. Press
Shuffle
again to cancel this mode.
Repeats a whole CD or track, DVD chapter, or DVD title. Press
Repeat
again
to cancel the repeat mode.
Getting strong remote control range and response
The cord that connects the power supply to the media center contains an antenna for your
RF remote. For good range, it is VERY important that you extend this cord to its full length
and keep it away from other system cables.
Note:
Also, when using a plasma screen TV, keeping the media center power supply as far from
the TV as is practical ensures better remote range.
If your system does not respond when you press a button on the remote, it could be time to
change batteries. For information on the type of batteries to use and how to change them,
refer to “Replacing the remote control batteries” on page 38.